I think it very likely that when it does reach parity, most of that functionality will be locked behind pay-per-use paywalls.Īnd perhaps consider moving to a different system that is not going to be a downgrade. It has a long ways to go before there is parity there, so do not be too eager to switch. Where is the best place to start to learn Fusion 360 as it looks like I will have to start learning anyway?Fusion is absolutely nowhere near as powerful as Featurecam. Where is the best place to start to learn Fusion 360 as it looks like I will have to start learning anyway?there's literally hundreds of threads here about fusion. Where is the best place to start to learn Fusion 360 as it looks like I will have to start learning anyway? Is it a mistake to try to start programming with Fusion 360 instead of a standalone CAM software? I think it is, personally, but boss man disagrees and thinks Fusion 360 is the answer going forward. I do have a decade or more experience with FeatureCAM and MasterCAM so in my mind it should be relatively comparable to them, but it does not seem to be. Keep in mind, I have only messed with it for a few hours and have no formal training or experience on it. So I have started messing around with Fusion, and it may just be me, but it seems clunky compared to FC and nowhere near as powerful. Hes an engineer and semi familiar with Fusion 360 and wants to start using it more and eventually gearing up to switch over to it completely for the inevitability that AD kills off FC. That being said, we have a new owner, hes the son of the original owner here and was already involved in the business so it was no major shake up with him buying the place.
![fusion 360 vs solidworks fusion 360 vs solidworks](https://stampar3d.com/wp-content/uploads/2021/06/fusion-360-KFociI.png)
But like many others have surely noticed, the writing seems to be on the wall for FeatureCAM. I have become pretty good at using FeatureCAM and do all the programming here. I was initially trained on MasterCAM in school but have not used it much since. Shop I work at has been using FeatureCAM for probably 15 years or more. What are everyones thoughts on programming in Fusion 360?